Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1870 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.3L - DTC P0016 TO P0336)DTC P0112 OR P0113CIRCUIT/SYSTEM TESTING
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Testing
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
- Ignition OFF, all vehicles systems OFF, this may take up to for 2 min, test for less than 5 Ξ© between the IAT low reference circuit terminal A and ground.
- If greater than the specified range, test the IAT low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
- Ignition ON, verify the scan tool IAT parameter is colder than -39Β°C (-38Β°F).
- If warmer than the specified range, test the IAT signal circuit terminal B for a short to ground. If the circuit tests normal, replace the ECM.
- Install a 3 A fused jumper wire between the IAT signal circuit terminal B and ground. Verify the scan tool IAT parameter is warmer than 149Β°C (300Β°F).
- If colder than the specified range, test the IAT signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the MAF/IAT sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.