Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1852 (ENGINE COOLING SYSTEM - HYBRID)COMPONENT LOCATORGENERATOR BATTERY TEMPERATURE SENSOR LOCATION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Generator Battery Temperature Sensor Location
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Generator Battery Temperature Sensor Location
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Sensor1 | Location2 |
|---|---|
| Hybrid Batt Mod 1 Temperature | Hybrid Battery Module 1 |
| Hybrid Batt Mod 2 Temperature | Hybrid Battery Module 14 |
| Hybrid Batt Mod 3 Temperature | Hybrid Battery Module 27 |
| Hybrid Batt Mod 4 Temperature | Hybrid Battery Module 40 |
| Hybrid Batt Outlet Air Temperature | Air Inlet Duct near hybrid battery fan |
| Hybrid Batt Inlet Air Temperature | Clipped above Hybrid Battery Module 3 |
| 1
Scan tool parameter name 2 Battery 1 is located next to cooling fan assembly. Battery 40 is located next to drive motor generator battery control module. |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.