SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1823 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSSTEERING GEAR BOOT REPLACEMENT (WITHOUT HP2)REMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
    2. Fig 1: Steering Linkage Inner Tie Rod & Nut
    GM1759516Courtesy of GENERAL MOTORS CORP.
  2. Remove the steering linkage inner tie rod nut (2) from the steering linkage inner tie rod (1).
    3. Fig 2: View Of Steering Gear Outer Boot Clamp & Boot
    GM1759500Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer boot clamp (2) from the steering gear boot (1).
    4. Fig 3: Identifying Steering Gear Boot Clamp & Boot
    GM1759493Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner boot clamp (1) from the steering gear boot (2) with side cutters.
  5. Discard the inner boot clamp.
  6. Remove the steering gear boot from the steering gear.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.