SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1812 (ANTILOCK BRAKE SYSTEM - HYBRID (HP2) WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSFRONT WHEEL SPEED SENSOR REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Front Wheel Speed Sensor Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Front Wheel Speed Sensor Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Wheel Speed Sensor
GM1858124Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to Brake Dust Warning .

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Front Brake Rotor Replacement (JD9, JF3, JF7, JG4) or Front Brake Rotor Replacement (JH6, JH7) .
1 Wheel Speed Sensor Electrical Connector Clip

Procedure

  1. Disconnect the electrical connector.
  2. Release the wheel speed sensor electrical connector clip from the brake hose bracket.
2 Wheel Speed Sensor Harness Clip
Procedure: 
Release the wheel speed sensor harness clip from the brake hose bracket.
3 Wheel Speed Sensor Harness Clip
Procedure: 
Release the wheel speed sensor harness clip from the steering knuckle bracket.
4 Wheel Speed Sensor Bolt
CAUTION: Refer to Fastener Caution .

Tighten:  13 N.m (115 lb in)
5 Wheel Speed Sensor
Procedure: 
Perform the Diagnostic System Check - Vehicle .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.