Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1708 (HYBRID CONTROLS - 3.6L (HP5) - INTRODUCTION)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Fastener Tightening Specifications
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric1 | English | |
| Accessory DC Power Control Module (APM) Bolts | 10 N.m | 89 lb in |
| Accessory DC Power Control Module (APM) Ground Strap Bolt | 22 N.m | 16 lb ft |
| Accessory DC Power Control Module (APM) Ground Strap Nut | 9 N.m | 80 lb in |
| Accessory DC Power Control Module (APM) Mounting Plate Nuts | 22 N.m | 16 lb ft |
| Accessory DC Power Control Module (APM) Mounting Plate Bolt | 9 N.m | 80 lb in |
| Ball Stud | 10 N.m | 89 lb in |
| Drive Motor Generator Control Module Assembly Support Bracket Bolts | 11 N.m | 97 lb in |
| Drive Motor Generator Control Module Assembly Mounting Nuts | 9 N.m | 80 lb in |
| Drive Motor Generator Control Module Assembly Mounting Retaining Bolt | 9 N.m | 80 lb in |
| Drive Motor Generator Power Inverter Coolant Pipe Bolts | 5 N.m | 44 lb in |
| Drive Motor Generator Power Inverter Module (PIM) 3 Phase Cable Housing Cover Fasteners | 9 N.m | 80 lb in |
| Drive Motor Generator Power Inverter Module (PIM) 3 Phase Cable Mounting Fasteners | 9 N.m | 80 lb in |
| Drive Motor Generator Power Inverter Module (PIM) 3 Phase Cable Terminal Fasteners | 9 N.m | 80 lb in |
| Drive Motor Generator Power Inverter Module (PIM) Cover Bolts | 5 N.m | 44 lb in |
| Engine Coolant Recovery Reservoir Support Fastener | 5 N.m | 44 lb in |
| Engine Coolant Recovery Reservoir Support Stud | 9 N.m | 80 lb in |
| High Voltage (HV) dc Accessory DC Power Control Module (APM) Terminal Fasteners | 9 N.m | 80 lb in |
| High Voltage (HV) dc Battery Cable Mounting Fasteners | 9 N.m | 80 lb in |
| High Voltage (HV) dc Battery Cable Terminal Fasteners | 9 N.m | 80 lb in |
| High Voltage (HV) dc Cable Cover Fasteners | 9 N.m | 80 lb in |
| High Voltage (HV) dc Electric Air Conditioning Compressor Module (ACCM) Cable Mounting Fasteners | 9 N.m | 80 lb in |
| High Voltage (HV) dc Electric Air Conditioning Compressor Module (ACCM) Cable Terminal Fasteners | 9 N.m | 80 lb in |
| Hybrid Cooling Surge Tank Fasteners | 7.5 N.m | 66 lb in |
| Hybrid Cooling Surge Tank Stud | 9 N.m | 80 lb in |
| Sight Shield Circuit Breaker Fasteners | 5 N.m | 44 lb in |
| Sight Shield Mounting Fastener | 5 N.m | 44 lb in |
| Shield Circuit Harness Terminal Fastener | 9 N.m | 80 lb in |
| Underhood Fuse Block Support Fastener | 5 N.m | 44 lb in |
| Windshield Washer Solvent Container Filler Tube Assembly Bolt | 10 N.m | 89 lb in |
| 1 N.m to kgf cm torque wrench formula = N.m value multiplied by 0.102 | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.