SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1686 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSGARAGE DOOR OPENER PROGRAMMING - UNIVERSAL (THREE LEDS)PROGRAMMING THE GDO FOR ROLLING CODE RECEIVERS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Programming the GDO for Rolling Code Receivers

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Programming the GDO for Rolling Code Receivers
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

This procedure is for training the customer's rolling code garage door openers to their GDO transmitter. The training process below must be completed within 30 seconds or it must be repeated.

  1. Press the two outside buttons on the GDO for one to two seconds and immediately release them.
  2. Locate the train button on the garage door opener receiver. Refer to the operator's manual for the garage door opener (or call 1-866-572-2728 for assistance). Follow instructions for the garage door opener in order to determine when the unit is in train mode.
  3. Return to the GDO transmitter in the vehicle, and press the button that you want trained for rolling codes 5 to 20 seconds. The LED above the button will flash slowly. When the garage door moves, release the button. The LED will then flash rapidly until programming is complete.
  4. Press the button used again in order to verify that the GDO transmitter has been programmed.

You may use either the hand-held transmitter or the GDO to open the garage door.

The GDO is compatible with most, but not all, types of garage door openers. If the GDO light does not flash rapidly after 90 seconds, there may be a compatibility conflict with the garage door opener. Call 1-866-572-2728 in order to address compatibility concerns.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.