SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1683 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER ARM REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Windshield Wiper Arm Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Windshield Wiper Arm Replacement
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper Arm
GM1876670Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Open and support the hood in order to access and remove the wiper blade assembly.
Special Tools: 
J 39637  Wiper Arm Puller. See Special Tools .
1 Windshield Wiper Arm Nut Cover
Tip:  Gently pry the cap from the wiper arm nut.
2 Windshield Wiper Arm Nut
CAUTION: Refer to Fastener Caution .

Procedure

  1. Gently rock the wiper arm side to side and remove.
  2. If the wiper arm fails to release, use the J 39637  to release the arm from the pivot shaft. See Special Tools .
  3. Hold the driver side wiper arm blade tip to the center dot located in the windshield blackout below the dot matrix while securing the nut.
  4. Hold the passenger side wiper arm blade tip to the passenger side outer dot located in the windshield blackout below the dot matrix while securing the nut.

Tighten:  25 N.m (18 lb ft)
3 Windshield Wiper Arm

Procedure

  1. Remove the wiper blade assembly from the wiper arm. Refer to Windshield Wiper Blade Replacement .
  2. Clean the transmission pivot shaft with a soft wire brush prior to installing the wiper arm back onto the pivot shaft.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.