Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1659 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY CURRENT SENSOR REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery Current Sensor

Courtesy of GENERAL MOTORS CORP.

Squeeze the battery positive and negative cable branches together.

IMPORTANT: Ensure the battery current sensor is installed in the correct direction and location on the battery positive and negative cable.

Slide the NEW battery current sensor (1) up onto the battery positive and negative cable to the location previously marked during removal.
Wrap electrical tape around the battery current sensor leg in order to secure the sensor to battery positive and negative cable.
Install the battery positive/negative cable clips to the locations previously marked during removal.
Install the battery positive and negative cable. Refer to Battery Positive and Negative Cable Replacement (LZ4) or Battery Positive and Negative Cable Replacement (LY7) or Battery Positive and Negative Cable Replacement (LE5) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.