Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1568 (POWER STEERING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Diagnostic Code Index
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC C0176 | C0176 54: System Thermal Error Temperature High |
| DTC C0460 | C0460 00: Steering Position Sensor |
| DTC C0475 | C0475 00: Electric Steering Motor Circuit |
| DTC C0545 | C0545 00: Steering Wheel Torque Input Sensor |
| DTC C0561 | C0561 71: System Disabled Information Stored Invalid Serial Data Received C0561 76: System Disabled Information Stored Below Allowable Range |
| DTC C056D | C056D 39: ECU Hardware Performance Internal Electronic Failure |
| DTC C056E | C056E 42: ECU Hardware Performance Calibration Data Set Not Programmed C056E 4B: ECU Software Performance Calibration Not Learned |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.