Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1542 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER ARM REPLACEMENT (LD)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Windshield Wiper Arm Replacement (LD)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Windshield Wiper Arm Replacement (LD)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Open the hood in order to access and remove the wiper arm assembly. |
|
| 1 | Windshield Washer Arm Finish Cap Tip: Use a small flat-bladed tool to remove the finish cap. |
| 2 | Windshield Washer Arm Nut
CAUTION:
Refer to Fastener Caution
. Tip: Hold the wiper blade to the vertical black bar target mark located at the lower center portion of the windshield. Tighten: 30 N.m (22 lb ft) |
| 3 | Windshield Washer Arm Hose Tip: Rotate the hose clockwise around the end of the washer wiper arm upon installation. |
| 4 | Windshield Washer Arm Assembly Tip: Use the J 39637 . Special Tools: J 39637 Wiper Arm Puller |
| 5 | Windshield Washer Blade Assembly Tip: Pinch the 2 outer tabs on the arm, rotate the blade rearward and slide the blade forward to release the wiper blade from the wiper arm assembly. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.