SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1525 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSREAR FENDER CLEARANCE LAMP REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Rear Fender Clearance Lamp Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Rear Fender Clearance Lamp Replacement
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Rear Fender Clearance Lamps
GM1913996Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Reach inside the rear fender and wheelhouse in order to disconnect the electrical connector for the rear fender lamp from the main chassis harness.
  2. Disengage the retainer securing the connector to the pick up box panel brace.
  3. From inside the wheelhouse push inward on the locking tab for the lamp assembly and push the lamp outward from the fender.
  4. Remove the lamp and electrical harness.
1 Rear Fender Clearance Lamps
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.