SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1524 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF SUNSHADE GUIDE REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Sunroof Sunshade Guide Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Sunroof Sunshade Guide Replacement
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Sunroof Sunshade Guide
GM2226148Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Sunshade Guides (Qty: 2)

Procedures

  1. If the sunshade guides are being replaced do the following:
  2. Hold sunshade in a partially closed position.
  3. Keeping one side of the sunshade located in the track, move the other side of the sunshade forward to free it from the track.
  4. Remove the other side of the sunshade from the track.
  5. Remove sunshade guides from the ends of the sunshade.
  6. Install new guides to both ends of the sunshade
  7. Install one end of the sunshade into the track.
  8. Keeping the installed end of the sunshade located in the track, install the other end by moving the shade forward then back into the track.

Tip:  Check for sunshade function.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.