SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1453 (ACCESSORY POWER SOCKET)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER OUTLET RECEPTACLE INOPERATIVECIRCUIT/SYSTEM DESCRIPTION
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Circuit/System Description

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Description
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The accessory power inverter module converts the 12-volt DC battery voltage to 108-125 volts AC to operate AC-powered devices. The accessory power inverter module provides up to 150 watts of power. The accessory power outlet is located on the left rear interior trim panel. The accessory power inverter module is located behind the left side rear quarter trim panel.

Battery voltage is supplied to the accessory power inverter module from the 25-amp ACPO fuse located in the auxiliary fuse block. The accessory power inverter module is grounded to the right rear D-pillar. When the engine is running, voltage, supplied by the FWD fuse, is supplied to the plug-inserted switches in the accessory power outlet. When a 115-volt AC powered device is plugged into the outlet, the normally-open plug-inserted switches, located internally in the accessory power outlet, close. The accessory power inverter module detects voltage on the signal circuit, and the accessory power inverter module supplies 115 volts AC to the accessory power outlet after a 1.5 second delay. The LED on the outlet illuminates to indicate that the outlet is powered.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.