Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
Each drive motor generator is controlled by a motor control module (MCM). The drive motor generators utilize 3 phase alternating current (ac) electricity. The drive motor generator stator coil is comprised of three phase circuits. The phase circuits are identified as phase U, phase V and phase W. The U-V-W phase circuits are connected in a wye configuration. This means each phase is connected at a single, central point. The MCM monitors a current sensor connected to each drive motor generator phase.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.