Digital Radio Receiver Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Digital Radio Receiver Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Digital Radio Receiver
GM1696470Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the right instrument panel insulator. Refer to Instrument Panel Insulator Replacement (Except Cadillac) or Instrument Panel Insulator Replacement (Cadillac) .
1 Digital Radio Receiver
Tip:Β 
  1. Disconnect the electrical connectors.
  2. Push in on the 2 tabs and pull down to remove the receiver.
  3. Perform the Digital Radio Receiver Setup. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.