High Mount Stop Lamp Replacement (Avalanche)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION High Mount Stop Lamp Replacement (Avalanche)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of High Mount Stop Lamp Assembly, Screws & Clips
GM1823410Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the center cargo bridge panel. Refer to Cargo Box Bridge Cross Bar Replacement (Escalade EXT) or Cargo Box Bridge Cross Bar Replacement (Avalanche) .
1 High Mounted Stop Lamp Attachment Clips (Qty: 2)
2 High Mount Stop Lamp Assembly Screw
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

3 High Mount Stop Lamp Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.