SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1370 (HVAC SYSTEM - AUTOMATIC)REPAIR INSTRUCTIONSRECIRCULATION ACTUATOR REPLACEMENT (LHD)INSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Recirculation Actuator Screws
    GM819756Courtesy of GENERAL MOTORS CORP.
  1. Install the recirculation actuator.
    2. NOTE: Refer to Fastener Notice .
  2. Install the recirculation actuator screws (1).

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

    3. Fig 2: View of Electrical Connector From Recirculation Actuator
    GM819755Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the recirculation actuator.
  4. Install the air inlet assembly. Refer to Air Inlet Assembly Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.