Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1351 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSADJUST LINK REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Adjustable Link Assembly

Courtesy of GENERAL MOTORS CORP.

Position the adjustable link (1) in the frame.

Fig 2: Identifying Mounting Bolts for Assembly

Courtesy of GENERAL MOTORS CORP.

Hand tighten the mounting bolts (1) and (2).

NOTE: Refer to Fastener Notice .

Tighten the adjustable link mounting bolts (2).
Tighten: Tighten the mounting bolt to 160 N.m (118 lb ft).
Tighten the adjustable link mounting bolts (1).
Tighten: Tighten the mounting bolt to 170 N.m (125 lb ft).
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Remove the support and 7 lower the vehicle.
Adjust the rear toe. Refer to Rear Toe Adjustment .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.