Windshield Wiper Transmission Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Windshield Wiper Transmission Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper Transmission Replacement
GM1970518Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the air inlet grille panel. Refer to Air Inlet Grille Panel ReplacementΒ .
1 Windshield Wiper Transmission Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  10 N.m (89 lb in)


Tip:Β  Secure the fender flange bolt first followed by the nut.
2 Windshield Wiper Transmission Nut

Tighten:Β  10 N.m (89 lb in)

3 Windshield Wiper Transmission Assembly

Procedure

  1. Raise the transmission assembly from the plenum and disconnect the wiper motor electrical connector.
  2. Remove the windshield wiper motor from the transmission. Refer to Windshield Wiper Motor ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.