SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1337 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENT (WITH CE4)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Windshield Washer Solvent Container Replacement (With CE4)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Windshield Washer Solvent Container Replacement (With CE4)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Solvent Container Replacement (With CE4)
GM1912982Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  2. Remove the front brake caliper cooling duct. Refer to Front Brake Caliper Cooling Duct Replacement (European) or Front Brake Caliper Cooling Duct Replacement (North America) .
  3. Disconnect the forward lamp harness electrical connectors from the windshield washer pump, headlamp washer pump and the windshield washer solvent level indicator.
  4. Disconnect the windshield washer pump hose at the pump spout.
  5. Disconnect the headlamp washer pump hose at the pump spout.
  6. Remove the windshield washer container cap.
1 Washer Container Screw (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Washer Container Nut

Tighten:  9 N.m (80 lb in)
3 Windshield Washer Solvent Container

Procedure

  1. Lift the washer solvent container from the stud on the front compartment panel assembly and lower the washer container from the wheelhouse compartment.
  2. Drain the windshield washer solvent into a suitable clean container.
  3. Transfer the component parts as needed.
  4. Install new grommets prior to installing the windshield and headlamp washer pumps and the level indicator into the washer solvent container.
  5. Fill the windshield washer solvent after completion.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.