SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1337 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD OUTSIDE MOISTURE SENSOR REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Windshield Outside Moisture Sensor Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Windshield Outside Moisture Sensor Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Outside Moisture Sensor Replacement
GM1978272Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Slide upward the plastic mirror harness cover.
  2. Disconnect the electrical connector at the top side of the windshield outside moisture sensor.
2 Windshield Outside Moisture Sensor Assembly

Procedure

  1. Pinch the tabs on both outer edges of the moisture sensor.
  2. Push the sensor upward from the windshield base.
  3. Remove the sensor from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.