Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Parking Brake Indicator Switch Bolt
    GM1970049Courtesy of GENERAL MOTORS CORP.
  1. Assemble the parking brake indicator switch bolt (1) to the parking brake indicator switch (2).
  2. Install the parking brake indicator switch assembly to the parking brake lever.

    Align the pin on the indicator switch to the locator hole on the parking brake lever.

  3. NOTE: Refer to Fastener Notice .
  4. Tighten the parking brake indicator switch bolt.

    Tighten:Β  Tighten the bolt to 7 N.m (62 lb in).

  5. Connect the parking brake indicator switch electrical connector.
  6. Install the left instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.