SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1328 (STEERING WHEEL & STEERING COLUMN)REPAIR INSTRUCTIONSSTEERING ANGLE SENSOR REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Steering Angle Sensor Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Steering Angle Sensor Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Angle Sensor Replacement
GM1919751Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
1 Steering Angle Sensor

Procedure

  1. Disconnect any electrical connectors as needed.
  2. Squeeze the plastic retaining tabs on the supplemental inflatable restraint steering wheel module coil to release and disengage the steering angle sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.