Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1327 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESNAVIGATION SYSTEM - VOICE GUIDANCE INOPERATIVE OR DEGRADED QUALITYCIRCUIT/SYSTEM TESTING
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Testing
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the radio harness connector X2 and VCIM harness connector X3.
- Test for less than 1 volt on the mono out circuit radio harness connector terminal 7 and ground.
- If greater than specified value, repair short to voltage.
- Test for greater than 1 ohm between the mono out circuit radio harness connector terminal 7 and ground.
- If less than specified value, repair short to ground.
- Test for less than 1 ohm between the mono out circuit radio harness connector terminal 7 and the microphone out signal circuit VCIM harness connector terminal 1.
- If greater than specified value, repair open circuit.
- Test for less than 1 volt on the low reference circuit radio harness connector terminal 15 and ground.
- If greater than specified value, repair short to voltage.
- Test for greater than 1 ohm between the low reference circuit radio harness connector terminal 15 and ground.
- If less than specified value, repair short to ground.
- Test for less than 1 ohm between the low reference circuit radio harness connector terminal 15 and the low reference signal circuit VCIM harness connector terminal 2.
- If greater than specified value, repair open circuit.
- If all circuits test normal, replace the radio.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.