Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1317 (WARNINGS AND CAUTIONS)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Section 1317 (Warnings And Cautions)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Section 1317 (Warnings And Cautions)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Introduction
- Definition of Caution, Notice, and Important
- ABS Component Handling Caution
- Actions to Take When Working with Fuel Caution
- Approved Equipment for Collision Repair Caution
- Assistant Driving Caution
- Automatic Transmission Range Selector Cable Caution
- Batteries Produce Explosive Gases Caution
- Battery Disconnect Caution
- Brake Dust Caution
- Brake Fluid Irritant Caution
- Breathing R-134a Caution
- Camshaft Holding Tool Caution
- Checking Hot Transmission Fluid through Drain Plug Hole Caution
- Collision Sectioning Caution
- Electric Coolant Fan Caution
- Exhaust Service Caution
- Express Window Down Caution
- Eye Protection Caution
- Foam Sound Deadeners Caution
- Fuel and Evaporative Emission Pipe Caution
- Fuel Gage Leak Caution
- Fuel Pipe Fitting Caution
- Fuel Rail Stop Bracket Installation Caution
- Fuel Storage Caution
- Fuel Vapors in Evaporative Emission Components Caution
- Gasoline/Gasoline Vapors Caution
- Glass and Sheet Metal Handling Caution
- Halogen Bulb Caution
- Hood Hold-Open Device Caution
- Hot Exhaust System Caution
- Lower O-Ring Removal Caution
- Moving Parts and Hot Surfaces Caution
- Protective Goggles and Glove Caution
- Radiator Cap Removal Caution
- Relieving Fuel Pressure Caution
- Road Test Caution
- Safety Glasses Caution
- Safety Glasses and Compressed Air Caution
- Safety Goggles and Fuel Caution
- SIR Caution
- SIR Deployed Inflator Modules Are Hot Caution
- SIR Dual Stage Inflator Module Handling Caution
- SIR Inflatable Module Deployment Outside Vehicle Caution
- SIR Inflator Module Coil Caution
- SIR Inflator Module Disposal Caution
- SIR Inflator Module Handling and Storage Caution
- SIR Side Impact Sensor Handling Caution
- SIR Special Tool Caution
- Vehicle Lifting Caution
- Window Retention Caution
- Work Stall Test Caution
- Anti-Corrosion Materials Notice
- Avoid Chipping or Scratching the Coating Notice
- Ball Stud Removal Notice
- Belt Dressing Notice
- Brake Fluid Effects on Paint and Electrical Components Notice
- Catalytic Converter Movement Notice
- Clearcoat/Ultraviolet Screeners Notice
- Clutch Hydraulic System Lubricant Notice
- Component Fastener Tightening Notice
- Constant Velocity Joint Seal Damage Notice
- Disengaging Connectors Notice
- Emission Modification Notice
- Engine Emission Notice
- Excessive Force and Oxygen Sensor Notice
- Exhaust System Inspection Notice
- Exterior Trim Emblem Removal Notice
- Fastener Notice
- Flex Decoupler Notice
- Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Notice
- Fuel Pressure Notice
- Fuel Tank Strap Fastener Notice
- Handling Electrostatic Discharge Sensitive Parts Notice
- Handling Idle Air Control Valve Notice
- Heated Oxygen and Oxygen Sensor Notice
- Heated Oxygen Sensor Resistance Learn Reset Notice
- Ignition OFF When Disconnecting Battery Notice
- J 35616-A Connector Test Adapter Kit Notice
- Liftgate Assist Rod Notice
- Machined Surface Damage Notice
- Nylon Fuel Lines Notice
- OBDII Symbol Description Notice
- Oxygen Sensor Notice
- Pin Reuse Notice
- Power Steering Hose Disconnected Notice
- Powertrain Control Module and Electrostatic Discharge Notice
- Retaining Ring Reuse Notice
- Seal Reuse Notice
- Sealant Notice
- Service Programming System (SPS) Notice
- Silicon Contamination of Heated Oxygen Sensors Notice
- Single Cylinder Flooding Notice
- Steering Column in Lock Position Notice
- Steering Wheel in the Full Turn Position Notice
- Steering Wheel Straight and Column Locked Notice
- Test Lamp to Test Continuity Notice
- Test Probe Notice
- Three-Way Catalytic Converter Damage Notice
- Torque Reaction Against Timing Drive Chain Notice
- Torque to Yield Bolts Notice
- Transfer Case Bearing Removal Notice
- Transfer Case Seal Removal Notice
- Valve Lifter Priming Notice
- Window Edge Damage Notice
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.