Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1260 (OBJECT DETECTION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B0967CIRCUIT/SYSTEM TESTING
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Circuit/System Testing
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the I/P multifunction switch assembly.
- Test for less than 1.0 ohm between ground circuit terminal 3 and ground.
- If greater than the specified range, test the ground circuit for a short to voltage or an open/high resistance.
- Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Enable.
- If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, test or replace the object alarm module.
- Connect a 10A fused jumper wire between signal circuit terminal 2 and ground.
- Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Disable.
- If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, test or replace the object alarm module.
- If all circuits test normal, test or replace the I/P multifunction switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.