SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1229 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Solvent Container & Screws
    GM1669972Courtesy of GENERAL MOTORS CORP.
  1. Transfer washer pumps and level indicator to the new washer solvent container.
    2. Fig 2: View Of Wheelhouse & Windshield Washer Solvent Container Assembly
    GM1733024Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield washer container assembly.
  3. Install the upper windshield washer container bolt to the auxiliary battery tray, if equipped.
    4. NOTE: Refer to Fastener Notice .
  4. Install the upper windshield washer solvent container bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  5. Install the auxiliary battery tray, if equipped. Refer to Battery Tray Replacement .
  6. Install the windshield washer solvent cap.
  7. Connect the electrical connectors.
    8. Fig 3: Locating Washer Pump Hoses
    GM1733021Courtesy of GENERAL MOTORS CORP.
  8. Connect the washer pump hoses (1, 2). Refer to Windshield Washer Hose Replacement .
  9. Install the lower outer washer container bolt.
  10. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
  11. Install the left front wheel assembly. Refer to Tire and Wheel Removal and Installation .
  12. Fill the washer solvent container with windshield solvent. Refer to Fluid and Lubricant Recommendations .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.