Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1219 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESVIDEO ENTERTAINMENT SYSTEM TROUBLESHOOTING HINTSDISCS WILL NOT EJECT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Discs Will Not Eject
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Discs Will Not Eject
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Attempt to remove the CDs/DVDs from the radio by pushing the "Eject" button on the radio. If there is a "chatter" noise, go to step two. If there is no chatter noise and the discs will not eject from the radio, send the radio to your authorized Electronic Service Center for repair.
- Remove the radio from the Instrument Panel of the vehicle but do not remove the electrical connectors. Refer to Radio Replacement (without RPO SLT) or Radio Replacement (with RPO SLT) .
- Some versions of these radios have a 9.5 mm x 13 mm oval hole on the top cover of the radio, near the back of the case. If the radio being serviced has this hole, proceed to step four. Otherwise the radio will need to be returned to your authorized Electronic Service Center for repair.
- Push the "Eject" button. While the discs are attempting to eject, insert a plastic pen cap, or similar plastic object into the hole to assist the top disc out of the radio.
- After the top disc is removed, push the "Eject" button again to remove the bottom disc.
- Check the operation of the radio to see if a CD or DVD can be inserted and then ejected. If a CD or DVD can be inserted and ejected from the radio, then reinstall the radio into the Instrument Panel. If a CD or DVD cannot be inserted and then ejected from the radio, send the radio to your authorized Electronic Service Center for repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.