SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1211 (INTERIOR TRIM AND PANELING)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Fastener Tightening Specifications

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Belt Assembly Anchor Bolt 70 N.m 52 lb ft
Body Lock Pillar Garnish Molding Screws 2 N.m 18 lb in
Body Rear Corner Upper Garnish Molding Screws 2 N.m 18 lb in
Center Pillar Upper Assist Handle Screws 1.2 N.m 10 lb in
Center Pillar Upper Garnish Molding Screws 2 N.m 18 lb in
Coat Hook Screws 9 N.m 80 lb in
Floor Console Bolts 6 N.m 53 lb in
Front Floor Console Rear Cupholder Screw 2 N.m 18 lb in
Jack and Tool Stowage Container Retaining Nut 5 N.m 44 lb in
Liftgate Trim Finish Panel Screw 2 N.m 18 lb in
Overhead Console Screws 2 N.m 18 lb in
Quarter Panel Trim Armrest Screws 2 N.m 18 lb in
Quarter Panel Trim Screws 2 N.m 18 lb in
Rear Assist Handle Screws 6 N.m 53 lb in
Side Door Armrest Bolt 2 N.m 18 lb in
Side Door Trim Panel Bolt 2 N.m 18 lb in
Sunshade Screws 6 N.m 53 lb in
Tool Storage Compartment Bracket Nuts 50 N.m 36 lb ft
Tool Storage Compartment Nuts 10 N.m 88 lb in
Windshield Side Garnish Molding Screws 2 N.m 18 lb in
Windshield Side Pillar Assist Handle Screws 6 N.m 53 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.