Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Descriptors
- DTC B0958 01
-
Parking Aid Rear Sensor 1 Left Corner Circuit Short to Battery
- DTC B0958 06
-
Parking Aid Rear Sensor 1 Left Corner Circuit Short to Ground or Open
- DTC B0958 08
-
Parking Aid Rear Sensor 1 Left Corner Circuit Signal Invalid
- DTC B0958 21
-
Parking Aid Rear Sensor 1 Left Corner Circuit Incorrect Period
- DTC B0959 01
-
Parking Aid Rear Sensor 1 Left Middle Circuit Short to Battery
- DTC B0959 06
-
Parking Aid Rear Sensor 1 Left Middle Circuit Short to Ground or Open
- DTC B0959 08
-
Parking Aid Rear Sensor 1 Left Middle Circuit Signal Invalid
- DTC B0959 21
-
Parking Aid Rear Sensor 1 Left Middle Circuit Incorrect Period
- DTC B0960 01
-
Parking Aid Rear Sensor 1 Right Middle Circuit Short to Battery
- DTC B0960 06
-
Parking Aid Rear Sensor 1 Right Middle Circuit Short to Ground or Open
- DTC B0960 08
-
Parking Aid Rear Sensor 1 Right Middle Circuit Signal Invalid
- DTC B0960 21
-
Parking Aid Rear Sensor 1 Right Middle Circuit Incorrect Period
- DTC B0961 01
-
Parking Aid Rear Sensor 1 Right Corner Circuit Short to Battery
- DTC B0961 06
-
Parking Aid Rear Sensor 1 Right Corner Circuit Short to Ground or Open
- DTC B0961 08
-
Parking Aid Rear Sensor 1 Right Corner Circuit Signal Invalid
- DTC B0961 21
-
Parking Aid Rear Sensor 1 Right Corner Circuit Incorrect Period
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.