SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1142 (OBJECT DETECTION SYSTEM)DESCRIPTION AND OPERATIONOBJECT DETECTION DESCRIPTION AND OPERATIONOBJECT ALARM SYSTEM DIC MESSAGESPARK ASSIST OFF
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Park Assist Off

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Park Assist Off
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

The PARK ASSIST OFF message is displayed in the DIC when the object alarm system is disabled due to conditions that disable or inhibit the system. The red LED in the rear display, as well as, the telltale in the switch will be lit, notifying the driver the PARK ASSIST system is disabled. The object alarm module requests the DIC via the serial data circuit to display PARK ASSIST OFF when it detects that one of the following conditions is true:

  • Object alarm system disabled through DIC vehicle customization feature. Refer to the Owners Manual for more information.
  • Automatic Object induced disable feature such as towing a trailer, bicycle rack, hitch receiver still attached to the vehicle.
  • The park brake is not fully released.
  • An object is hanging out of the endgate.
  • The system receives vibrations from a large nearby vehicle or from a heavy equipment such as a jackhammer.

In the case of towing a trailer, the PARK ASSIST OFF message will continue to be displayed until the trailer hitch receiver is removed and the vehicle is driven forward above 24 km/h (15 mph).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.