SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1125 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)COMPONENT LOCATORANTILOCK BRAKE SYSTEM CONNECTORSSTEERING ANGLE SENSOR (JL4)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Steering Angle Sensor (JL4)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Steering Angle Sensor (JL4)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Angle Sensor (JL4) Connector End Views
GM280793Courtesy of GENERAL MOTORS CORP.
Steering Angle Sensor (JL4) Connector Parts Information

Connector Part Information 
  • OEM: 12052444
  • Service: 12101874
  • Description: 8-Way F Micro-Pack 100 Series (BK)

Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
Steering Angle Sensor (JL4) Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 0.35 GY 6044 5-Volt Reference
2 0.35 OG/BK 6045 Low Reference
3 0.35 YE 6046 Steering Angle Sensor Phase A
4 0.35 D-BU 6047 Steering Angle Sensor Phase B
5 0.35 TN 6048 Steering Angle Sensor Phase C
6 0.35 L-GN 6043 Steering Angle Sensor Signal
7-8 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.