Rear Pillar Speaker Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Rear Pillar Speaker Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Pillar Speaker
GM1800084Courtesy of GENERAL MOTORS CORP.
Rear Pillar Speaker Replacement

Callout Component Name
Preliminary Procedure:Β 
Remove the body lock pillar trim. Refer to Body Lock Pillar Trim Replacement (Regular Cab) or Body Lock Pillar Trim Replacement (Extended Cab) or Body Lock Pillar Trim Replacement (Crew Cab) .
1 Rear Pillar Speaker Screw
NOTE: Refer to Fastener Notice .

Tighten:Β  3 N.m (25 lb in)

2 Rear Pillar Speaker
Tip:Β  Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.