SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1087 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENT (2500, 3500)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Inflatable Restraint Front End Sensor Replacement (2500, 3500)

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Inflatable Restraint Front End Sensor Replacement (2500, 3500)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Inflatable Restraint Front End Sensor & Bolt
GM1714061Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Front End Sensor Replacement (2500, 3500)

Callout Component Name
CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
Preliminary Procedure: Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
1 Supplemental Inflatable Restraint Front End Discriminating Sensor Bolt (Qty: 1)
NOTE: Refer to Fastener Notice .

Tip:  Loosen bolt in order to remove sensor.

Tighten:  8 N.m (71 lb in)
2 Supplemental Inflatable Restraint Front End Discriminating Sensor Assembly
Tip: 
  1. Remove connector position assurance (CPA) retainer.
  2. Disconnect electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.