Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1006 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSINFORMATION CENTER TELLTALE ASSEMBLY REPLACEMENT (TAHOE/SUBURBAN/YUKON/YUKON XL)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2
Information Center Telltale Assembly Replacement (Tahoe/Suburban/Yukon/Yukon XL)
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Information Center Telltale Assembly Replacement (Tahoe/Suburban/Yukon/Yukon XL)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Information Center Telltale Assembly Replacement (Tahoe/Suburban/Yukon/Yukon XL)
| Callout | Component Name |
|---|---|
| 1 | Rear Corner Garnish Molding Assembly Refer to Garnish Molding Replacement - Rear Corner (Tahoe/Suburban) . |
| 2 | Information Center Telltale Screw (Qty: 2)
NOTE:
Refer to Fastener Notice
.
Tighten: 2 N.m (18 lb ft) |
| 3 | Information Center Telltale Assembly Tip: Disconnect electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.