SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1005 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSASSIST STEP REAR BRACKET REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Assist Step Rear Bracket Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Assist Step Rear Bracket Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Power Assist Step Rear Bracket, Rear Bracket Nuts & Bolts
GM1813941Courtesy of GENERAL MOTORS CORP.
Assist Step Rear Bracket Replacement

Callout Component Name

Preliminary Procedures

  1. Deploy and support the power assist step.
  2. Use a grease pencil to outline the location of the power assist step rear bracket location on the power assist step.
  3. Remove the power assist rear bracket to power assist step bolts. Refer to Assist Step Replacement (Manual)  or Assist Step Replacement (Z71 )  or Assist Step Replacement (Power) 
1 Power Assist Step Rear Bracket Bolts (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  6 N.m (53 lb in)
2 Power Assist Step Rear Bracket Nuts (Qty: 3)

Tighten:  10 N.m (89 lb in)
3 Power Assist Step Rear Bracket
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.