SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY REPLACEMENT (SECONDARY)REMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
CAUTION: Batteries produce explosive gases. Batteries contain corrosive acid. Batteries supply levels of electrical current high enough to cause burns. Therefore, in order to reduce the risk of personal injury while working near a battery, observe the following guidelines:
  • Always shield your eyes.
  • Avoid leaning over the battery whenever possible.
  • Do not expose the battery to open flames or sparks.
  • Do not allow battery acid to contact the eyes or the skin.
    • Flush any contacted areas with water immediately and thoroughly.
    • Get medical help.
  1. Disconnect the battery negative cable from the negative battery terminal. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Disconnected Battery Negative Cable From Auxiliary Battery
    GM105191Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the auxiliary negative cable from the battery terminal.
  4. Disconnect the auxiliary battery positive cable from the battery terminal.
    5. Fig 2: Removed Auxiliary Battery, Battery Hold-Down Retainer Bolt And Retainer
    GM184057Courtesy of GENERAL MOTORS CORP.
  5. Remove the battery hold down retaining bolt.
  6. Remove the battery from the tray.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.