SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT REPLACEMENT - REAR BENCHINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Installation Procedure
    Fig 1: Rear Bench Seat
    GM333672Courtesy of GENERAL MOTORS CORP.
  1. Position the seat into the vehicle.
    2. Fig 2: Rear Bench Seat Floor Rails
    GM333671Courtesy of GENERAL MOTORS CORP.
  2. Align the seat attaching points with the slots in the floor rail.
  3. Push the seat forward in the rail to lock the front of the seat risers onto the slots on the inside of the floor rail.
    4. Fig 3: Rear Of Seat Riser Locking Pin
    GM333666Courtesy of GENERAL MOTORS CORP.
  4. Remove the locking pin (3) from the stored position at the rear of the seat riser (2).
    5. Fig 4: Rear Of Seat Riser Locking Pin & Retainer
    GM783237Courtesy of GENERAL MOTORS CORP.
  5. Locate the hole in the floor rail at the rear of the seat riser (2) and insert the locking pin.
  6. Rotate the locking pin (3) forward into the retaining clip.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.