SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSLOWER BEARING AND STEERING COLUMN JACKET REPLACEMENT (COLUMN SHIFT TILT)REMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the shift lever assembly. Refer to Shift Lever Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  4. Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  5. Remove the tilt spring assembly only. Refer to Tilt Spring Replacement .
  6. Inspect the steering column for accident damage. Refer to Steering Column Accident Damage Inspection .
    7. Fig 1: Turn Signal & Multifunction Switch Assembly & Screws
    GM324887Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 pan head tapping screws from the turn signal and multifunction switch assembly.
  8. Remove the turn signal and multifunction switch assembly.
    9. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.