Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIMREPAIR INSTRUCTIONSHEADLINER REPLACEMENT - REARREMOVAL PROCEDURE

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Removal Procedure

CAUTION: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.

Fig 1: Rear Headliner

Courtesy of GENERAL MOTORS CORP.

Remove the rear passenger seats. Refer to Seat Replacement - Rear Bench in Seats.
Remove the front headliner. Refer to Headliner Replacement - Front .
Remove the coat hooks. Refer to Coat Hook Replacement .
Remove the left rear upper garnish molding. Refer to Garnish Molding Replacement - Left Body Side Upper .
Remove the rear door garnish molding. Refer to Garnish Molding Replacement - Rear Door Upper .
Remove the rear corner garnish molding. Refer to Garnish Molding Replacement - Rear Corner .
Remove the upper seat belt anchor bolts.
- Refer to the following in Restraints:
- Seat Belt Retractor Replacement - No. 2 Left Rear
- Seat Belt Retractor Replacement - No. 2 Right Rear
- Seat Belt Retractor Replacement - No. 3 Left Rear
- Seat Belt Retractor Replacement - No. 3 Right Rear
Disconnect the electrical connectors.
Remove the headliner from the vehicle through the rear doors

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.