SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 901 (DATA COMMUNICATION SYSTEM)COMPONENT LOCATORDATA COMMUNICATION CONNECTORSBODY CONTROL MODULE (BCM) - C6 (PRP)
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30

Body Control Module (BCM) - C6 (PRP)

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Body Control Module (BCM) - C6 (PRP)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, 2007 Chevrolet RV Cutaway, and 2007 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) - C6 (PRP) Connector End View
GM362758Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) - C6 (PRP) Connector & Terminal Parts Information

Connector Part Information 
  • OEM: 12191375
  • Service: 15306041
  • Description: 16-Way F Micro-Pack 100 Series (PU)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
Body Control Module (BCM) - C6 (PRP) Terminal Identification

Pin Wire Color Circuit No. Function
A1 D-BU/WH 149 Dome Fluorescent Work Lamp Signal (UF2)
A2-A6 - - Not Used
A7 L-BU 1344 Access Panel Right Side Relay Control
A8 GY/BK 690 Dome Fluorescent Work Lamp Relay Control (UF2)
B1-B6 - - Not Used
B7 L-GN 1391 Access Panel Left Side Rear Relay Control
B8 L-BU 244 Access Panel Left Side Front Relay Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.