SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2000 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSAUDIO SYSTEM TRANSCEIVER MODULE REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30

Audio System Transceiver Module Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Audio System Transceiver Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Audio System Transceiver Module
GM1746253Courtesy of GENERAL MOTORS CORP.
Audio System Transceiver Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the video display assembly. Refer to Video Display Replacement (Second Row) , Video Display Replacement (Third Row) .
1 Roof Console Assembly
Refer to Roof Rear Console Replacement (with DVD) , Roof Rear Console Replacement (w/o DVD) .
2 Audio System Transceiver Module Assembly
  1. Disconnect the electrical connector.
  2. Use a flat bladed tool to release the tabs that secure the module to the roof console on each side of the module.
  3. Slide forward and up to release from the roof console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.