SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1665 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSPOWER STEERING CONTROL MODULE PROGRAMMING AND SETUP (WITHOUT HP5)POWER STEERING CONTROL MODULE (PSCM) REPLACEMENT & SETUP
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30

Power Steering Control Module (PSCM) Replacement & Setup

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Power Steering Control Module (PSCM) Replacement & Setup
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The power steering control module is serviced separately from the steering column assembly.

If the Power Steering Control Module is replaced, the following procedures must be performed in the following order:

  1. 1. PSCM reprogramming, refer to Service Programming System (SPS) 
  2. 2. Steering Position/Torque Sensor Calibration
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.