Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
The scan tool data definitions contain a brief description of all object detection system related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.
- Battery Voltage
-
The scan tool displays 0-20 volts. This is the system voltage measured by the object detection module between the battery input and ground.
- Calibration Part Number
-
Displays the object detection module calibration part number.
- Component Serial Number 13-16
-
Displays the object detection module component serial number.
- End Model Part Number
-
The scan tool displays the part number that represents the combination of hardware/software/calibrations present in the object detection module.
- Loudspeaker Feed Voltage Output
-
The scan tool displays the output feed voltage to the radio is measure by volts/counts.
- Park Assist Switch
-
The scan tool displays whether the object detection system is active or inactive.
- Park Assist Rear Display LED CKT
-
The scan tool displays whether the rear display for the object detection system is OK or over current.
- Park Assist System Status
-
The scan tool displays whether the object detection system is enable, disable, inhibit, or failed.
- Power Mode
-
The scan tool displays whether the object detection system is Off, accessory, run, or crank request.
- Sensor Feed Voltage Output
-
The scan tool displays what voltage is being sent to the object sensors.
- Vehicle Speed
-
The scan tool displays the speed of vehicle.
- Year Module Built
-
The scan tool displays the year the object detection module was built.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.