SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1142 (OBJECT DETECTION SYSTEM)COMPONENT LOCATOROBJECT DETECTION CONNECTORSREAR OBJECT SENSOR CONTROL MODULE X1
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30

Rear Object Sensor Control Module X1

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Rear Object Sensor Control Module X1
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Object Sensor Control Module X1 Connector End View
GM1715212Courtesy of GENERAL MOTORS CORP.
Rear Object Sensor Control Module X1 Connector Parts Information

Connector Part Information 
  • OEM: 13551679
  • Service: 19115653
  • Description: 8-Way F Kaizen 0.64 Series (GY)
Terminal Part Information 
  • Terminal/Tray: 7116-4618-02/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215/J-35616-64B (L-BU)
Rear Object Sensor Control Module X1 Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 0.5 PU 2378 RR Corner Object Sensor Signal
2 0.5 D-GN 2377 RR Middle Object Sensor Signal
3 0.5 OG 2376 LR Middle Object Sensor Signal
4 0.5 D-BU 2374 Object Sensor Supply Voltage
5 0.5 YE 2375 LR Corner Object Sensor Signal
6-7 - - Not Used
8 0.5 GY 2379 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.