Auxiliary Body Control Module Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Auxiliary Body Control Module Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Auxiliary Body Control Module
GM1897790Courtesy of GENERAL MOTORS CORP.
Auxiliary Body Control Module Replacement

Callout Component Name
Preliminary Procedures:Β 
Remove the inflatable restraint module. Refer to INSTRUMENT PANEL INFLATABLE RESTRAINT MODULE REPLACEMENT (WITH SLT)INSTRUMENT PANEL INFLATABLE RESTRAINT MODULE REPLACEMENT (WITHOUT SLT) .
1 Auxiliary Body Control Module

Procedure

  1. Press on the tabs to release the auxiliary body control module.
  2. Disconnect the electrical connectors.
  3. Reprogram the auxiliary body control module if replaced. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.