Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DRIVE AXLESPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30
Special Tools
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Special Tools
Special Tools
| Illustration | Tool Number/Description |
|---|---|
| J 2222-C Wheel Bearing Nut Wrench |
|
| J 2619-01 Slide Hammer |
|
| J 7818 Inner Bearing Race Installer |
|
| J 8001 Dial Indicator Set |
|
| J 8092 Universal Driver Handle - 3/4 in - 10 |
|
| J 8611-01 Rear Pinion Bearing Race Installer |
|
| J 8614-01 Flange and Pulley Holding Tool |
|
| J 21128 Axle Pinion Oil Seal Installer |
|
| J 21784 Side Bearing Installer |
|
| J 22388 Pinion Oil Seal Installer - Rear |
|
| J 22536 Pinion Driver |
|
| J 22779 Side Bearing Backlash Gage |
|
| J 22888-D Side Bearing Remover Kit |
|
| J 22912-01 Split-Plate Bearing Puller |
|
| J 23690 Bearing Installer |
|
| J 24426 Wheel Bearing Race Installer - Outer |
|
| J 24427 Wheel Bearing Race Installer - Inner |
|
| J 24429 Side Bearing Backlash Spanner |
|
| J 24430 Differential Side Bearing Installer |
|
| J 24433 Pinion Cone and Side Bearing Installer |
|
| J 25025 Guide Pins |
|
| J 25588 Side Bearing Shim Installer |
|
| J 29712 Wheel Bearing Remover |
|
| J 34925 Pinion Setting Gage and Components |
|
| J 36597 Side Bearing Puller Pilot - 9.25 inch |
|
| J 36660-A Torque Angle Meter |
|
| J 38694 Extension Housing Oil Pump/Seal Installer |
|
| J 37624 Pinion Bearing Installer |
|
| J 42176 Universal Driver Handle - Non-Threaded |
|
| J 44417 Rear Pinion Bearing Race Installer |
|
| J 44419 Hub Outer Bearing Race Installer |
|
| J 44420 Differential Bearing and Hub Seal Installer |
|
| J 44685 Rear Axle Seal and Bearing Remover |
|
| J 45692 Pinion Shim Selector Kit - Dana Axles |
|
| J 45703 Pinion Bearing Race Remover - Dana 248 |
|
| J 45704 Pinion Bearing Race Installer - Dana 248 |
|
| J 45705 Pinion Bearing Race Remover - Dana 248/267 |
|
| J 45706 Pinion Bearing Race Remover - Dana 286 |
|
| J 45710 Pinion Bearing Oil Seal Installer |
|
| J 45711 Differential Side Bearing Remover - Dana 248 |
|
| J 45853 Rear Axle Shaft Bearing/Seal Installer |
|
| J 45870 Pinion Bearing Cup Installer |
|
| J 45900 Differential Side Bearing Installer - Dana Axles |
|
| DT 46725 Side Bearing Installer |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.