Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Removal Procedure
    Fig 1: Wiper Arm Nut
    GM497988Courtesy of GENERAL MOTORS CORP.
  1. Set the wipers in the Park position.
  2. Disconnect the washer hose elbow from the air inlet grille panel.
  3. Remove the cover from the nut on the wiper arm.
  4. Remove the nut from the wiper arm.
  5. IMPORTANT: If rocking the wiper arm fails to loosen the arm from the drive shaft, use a J 39822Β  or a battery terminal puller to remove the wiper arm. See Special ToolsΒ .
  6. Rock the wiper arm back and forth to loosen arm from the drive shaft.
  7. Remove the wiper arm from the drive shaft.
  8. Remove the wiper blade from the wiper arm. Refer to Wiper Arm Blade ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.