Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Installation Procedure
    Fig 1: Lower Center Windshield & Black Locator Dots
    GM783835Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper blade onto the wiper arm. Refer to Wiper Arm Blade ReplacementΒ .
  2. IMPORTANT: Do not interchange the LH and RH wiper arms.
    The wiper arms are stamped with LH and RH.
  3. Install the wiper arm onto the drive shaft while aligning the center of the wiper blade to the black locator dots (3) on the lower center windshield (2).
  4. Fig 2: Wiper Arm Nut
    GM497988Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.