Installation Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Installation Procedure
    Fig 1: Washer Pump
    GM497987Courtesy of GENERAL MOTORS CORP.
  1. Install the new washer pump into the washer solvent container.
  2. Install the washer solvent container cap.
  3. Fig 2: Washer Hose & Electrical Connector
    GM497985Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the new washer pump.
  5. Connect the washer hose to the new washer pump.
  6. Position the washer solvent container into the locating holes in the chassis.
  7. Fig 3: Washer Solvent Container Bolt
    GM497983Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.